Table of Contents
Advertisement
Take a USB board, a USB hub and a connect cable.
Connect the cable to the USB board, then locate the
USB board into the USB hub. Stick 1pcs aluminum
foil on one side of the USB hub, then locate the
S13
USB unit into the hook of a rear cover. Use a
Philips-head screwdriver to tighten one screw for
locking the USB unit with the rear cover.
(No.1 screw size=M3x6, Torque=4
Move the assembled rear cover close to the
panel unit, then connect the USB FFC cable to
the connector of interface board. Put down the
S14
rear cover and push the rear cover on the
positions marked as the picture below shown for
mechanisms engagement.
5. Disassembly and Assembly Procedures
0.5kgfxcm)
±
1
Use a Philips-head screwdriver to tighten 4pcs
screws for locking rear cover with the assembled
S15
unit.
(No.1~4 screw size=M4x10; Torque=12 0.5kgfxcm)
2
4
Stick 2pcs labels on the specific positions as the
picture below shown. Fit the two tabs on the upper
S16
part of the stand into the grooves on the back of the
monitor, and then press the stand so that the
monitor mounting area snaps onto the stand.
L
ift up the monitor, then provide power supply and a
S17
video signal to the monitor
for functionality check.
±
3
1
, then turn on the monitor
Advertisement
Table of Contents
