Table of Contents
Advertisement
5.2 Assembly Procedures:
Place a bracket chassis base on a protective
S1
cushion.
Turn over a power board and put the power board
S2
into the bracket chassis, locate the panel power
cable into the hook of the bracket chassis.
Take a interface board, connect a LVDS cable to the
connector of the interface board, then connect the
cable of the power board to the connector of the
interface board. Turn over the interface board and
S3
locate it into the bracket. Use a Philips-head
screwdriver to tighten six screws for locking the
power board and interface board.
(No.1~5 screw size=M3x7.5, Torque=6
No.6 screw size=M4x8, Torque=6
2
5. Disassembly and Assembly Procedures
kgfxcm;
±0.5
kgfxcm)
±0.5
3
4
5
6
1
Take a mylar to insert the hooks of the bracket to
S4
cover the power board.
Use a Hex-head screwdriver to tighten two Hex Nuts
for locking the D-Sub connector.
(No.1~2 screw size=M3x8, Torque=6±0.5kgfxcm)
S5
Use a Philips-head screwdriver to tighten two screws
for locking the AC power outlet.
(No.3~4 screw size=M3x8, Torque=6~7kgfxcm;
2
Panel preparation: Examine the panel surface
S6
according to inspection criteria. Turn over the panel
to place the screen faced down for later assembling.
Put the bracket chassis module on the back of LCD
S7
module, then lift up the panel with bracket and take
1pcs front bezel to assemble with the panel module.
1
4
3
Advertisement
Table of Contents
