Table of Contents
Advertisement
...the wash results are not satisfactory
The dishes are not clean
The wrong washing programme has been selected.
The dishes were arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded.
The spray arms do not rotate freely due to wrong arrangement of the load.
The filters in the base of the washing compartment are dirty or incorrectly positioned.
Too little or no detergent has been used.
Where there are limescales deposits on the dishes; the salt container is empty or the wrong level of the water softener has been
selected.
The drain hose connection is not correct.
The salt container cap is not properly closed.
The dishes are wet and dull
Rinse aid was not used.
The rinse aid dispenser is empty.
There are streaks, milky spots or a bluish coating on glasses and dishes
Decrease rinse aid dosing.
Water drops have dried onto glasses and dishes
Increase rinse aid dosing.
The detergent may be the cause. Contact the detergent manufacturer's consumer care line.
If after all these checks, the problem persists, contact your
local consumer services department, quoting the model
(Mod.), product number (PNC) and serial number (S.N.).
This information can be found on the rating plate located on
the right hand side of the dishwasher door (see picture).
So that you always have these numbers at hand, we
recommend you to make a note of them here:
Mod. : . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . .
S.N. :. . . . . . . . . . . . . . . . . . .
Service and spare parts
This product should be serviced by an authorised service
engineer, and only genuine spare parts should be used.
Under no circumstances should you attempt to repair the
machine yourself.
Repairs carried out by inexperienced persons may cause injury
or serious malfunctioning. Contact your local consumer
services department.
Always insist on genuine spare parts.
All manuals and user guides at all-guides.com
RA08
Security system
Inlet hose
The
inlet hose has a high pressure resistance.
It can sustain pressures up to 6000 kPa (60 bar), 6 times a
normal hose.
As a further safeness, the inlet hose is protected with a
sheathing against eventual damages.
In case of breakage of the inner hose, the water that is in the
special hose will become dark, this is visible across the special
transparent sheathing.
In this case turn off the water tap and call the consumer
services department.
The
inlet hose is also fitted with a safety device to
prevent inadvertent loosening.
To detach the hose, press the lever "B" and turn the retaining
ring "A" anticlockwise.
29
A
B
CA14
Advertisement
Table of Contents
