Table of Contents
Advertisement
Starting a washing programme
In this fully integrated appliance, the controls are located on
the top of the door. When selecting a programme, the door
needs to be slightly open.
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Press the On/Off push button
The On/Off indicator light comes on
4. Setting and starting the programme
Press the programme push button which corresponds to
the programme you wish to select (see "Washing
programmes" chart).
The corresponding indicator light will start flashing.
It is possible to change the programme selection simply
pressing another programme push button.
Close the door, the programme will start automatically, an
audible signal advises you that the programme has
started and the programme indicator light will remain lit
with a static light.
5. Interrupting/cancelling a washing
programme
Change or interrupt a washing programme in
progress ONLY if it's absolutely necessary
To interrupt a washing programme
Attention! Hot steam may escape when the door is
opened. There is risk of scalding. Open the door
carefully.
Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the
point in which it was interrupted.
Pressing the On/Off (in this case all the indicator
lights turn off). Press the On/Off push button again;
the programme will start from the point in which it was
interrupted.
To cancel a washing programme
Open the door and press the push button of the running
programme for about 1 second, until the indicator light
of the programme turns off.
The programme has been cancelled and the dishwasher
has returned to setting mode, it is now possible to select
a new washing programme.
All manuals and user guides at all-guides.com
26
6. End of the washing programme
The dishwasher will automatically stop and an
intermittent audible signal will be heard when the
programme has ended.
The indicator light of the programme just ended turns off
and the "end of programme" indicator light starts
flashing.
Wait until the end of the audible signal before opening
the door. (Note: if during the end of programme audible
signal the door is opened, the dishwasher will anyhow
complete both audible signal and programme)
Hot steam may escape from the appliance when opening
the door immediately after the end of the programme,
therefore, open the door carefully.
Open the door and switch off the dishwasher by pressing
the On/Off push button or select a new washing
programme by pressing one of the programme push
buttons.
Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Leave the dishes in the dishwasher for approx. 15
minutes, with the door ajar, after the end of programme
so that they dry better and will be cooler.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
Advertisement
Table of Contents
