Vitek VT-2561 Manual Instruction page 4

ENGLISH
•
Clean the cut hair off the blade block with the brush after
each use.
•
Never leave the operating unit unattended.
•
Switch the unit off during intervals in operation or when you
are not using it.
•
Do not allow children to touch the power adapter body while
the battery is being charged.
•
Do not allow children to use the unit as a toy.
•
This unit is not intended for usage by children.
•
During the unit operation and breaks between operation cy-
cles, place the unit out of reach of children and people with
disabilities.
•
The unit is not intended for usage by persons with physical or
mental disabilities (including children) or by persons lacking
experience or knowledge if they are not under supervision of
a person who is responsible for their safety or if they are not
instructed by this person on the usage of the unit.
•
Close supervision is necessary when children or people with
disabilities are near the operating unit.
•
For children safety reasons do not leave polyethylene bags
used as a packaging unattended.
ATTENTION! Do not allow children to play with polyethylene
bags or packaging film. Danger of suffocation!
•
Do not attempt to repair the unit by yourself. Do not dis-
assemble the unit by yourself, if any malfunction is de-
tected or after it was dropped, unplug the unit and contact
any authorized service center from the contact address
list given in the warranty certificate and on the website
www.vitek.ru.
•
To avoid damages, transport the unit in the original packag-
ing only.
•
Keep the unit in a dry cool place out of reach of children and
people with disabilities.
THE UNIT IS INTENDED FOR HOUSEHOLD USE ONLY, ITS COM-
MERCIAL USAGE AND USAGE IN PRODUCTION AREAS AND
WORK SPACES IS PROHIBITED.
BEFORE THE FIRST USE
After the unit transportation or storage at low temperature
keep it for at least three hours at room temperature before
switching on.
– Unpack the unit completely and remove any package materi-
als and advertising stickers that prevent the unit operation.
– Check the unit for damages; do not use a damaged unit.
– Before plugging the trimmer in to charge the battery, make
sure that voltage of the mains corresponds to the power
adapter operating voltage.
– Charge the battery and lubricate the blade block following the
recommendations below.
4
21.05.2018 10:35:31