Troubleshooting - Toro Recycler 22275 Operator's Manual

Troubleshooting

Perform only the steps described in these instructions. All further inspection, maintenance, and repair work
must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the
problem yourself.
Problem
The machine does not run or does not run
continuously.
The machine does not reach full power.
The machine or motor is producing
excessive vibration or noise.
The is an uneven cutting pattern.
The discharge chute plugs up.
The machine does not self-propel.
The battery pack loses charge quickly.
The battery charger is not working.
Possible Cause
1. The battery is not fully installed in the
machine.
2. The battery pack is not charged.
3. The battery pack is damaged.
4. There is another electrical problem
with the machine.
1. The battery pack charge capacity is
too low.
2. The underside of the machine contains
clippings and debris.
1. The blade is bent or is out of balance.
2. The blade mounting nuts are loose.
3. The underside of the machine contains
clippings and debris.
4. The motor mounting bolts are loose.
1. All 4 wheels are not at the same height.
2. The blade is dull.
3. You are mowing in the same pattern
repeatedly.
4. The underside of the machine contains
clippings and debris.
1. The throttle lever is not in the F
position.
2. The cutting height is too low.
3. You are mowing too fast.
4. The grass is wet.
5. The underside of the machine contains
clippings and debris.
1. The self-propel drive cable is out of
adjustment or is damaged.
2. There is debris under the belt cover.
1. The battery pack is over or under the
appropriate temperature range.
2. The machine is overloaded
1. The battery charger is over or under
the appropriate temperature range.
2. The outlet that the battery charger is
plugged into does not have power.
28
Corrective Action
1. Remove and then replace the battery
into the machine, making sure that it is
fully installed and latched.
2. Remove the battery pack from the
machine and charge it.
3. Replace the battery pack.
4. Contact an Authorized Service Dealer.
1. Remove the battery pack from the
machine and fully charge the battery
pack.
2. Clean the underside of the machine.
1. Balance the blade. If the blade is bent,
replace it.
2. Tighten the blade mounting nuts.
3. Clean the underside of the machine.
4. Tighten the motor mounting bolts.
1. Place all 4 wheels at the same height.
2. Sharpen and balance the blade.
3. Change the mowing pattern.
4. Clean the underside of the machine.
1. Move the throttle lever to the F
AST
position.
2. Raise the cutting height.
3. Slow down.
4. Allow the grass to dry before mowing.
5. Clean the underside of the machine.
1. Adjust the self-propel drive cable.
Replace the cable if necessary.
2. Clean the debris from under the belt
cover.
1. Move the battery pack to a place
where it is dry and the temperature is
between 5°C (41°F) and 40°C (104°F).
2. Work at a slower pace.
1. Unplug the battery charger and move
it to a place where it is dry and the
temperature is between 5°C (41°F)
and 40°C (104°F).
2. Contact your licensed electrician to
repair the outlet.
AST