Setup; Mounting The Battery Charger (Optional) - Toro Recycler 22275 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
Important:
Remove and discard the protective
plastic sheet that covers the motor and any other
plastic or wrapping on the machine.
Important:
The battery pack is not fully charged
when it is purchased. Before using the machine
for the first time, refer to
Pack (page 21).
1
Mounting the Battery
Charger (Optional)
Parts needed for this procedure:
2 Mounting hardware (not included)
Procedure
If desired, mount the battery charger securely on a
wall using the wall-mount key holes on the back of
the charger.
Mount it indoors (such as a garage or other dry place),
near a power outlet, and out of the reach of children.
Refer to Figure 3 for assistance in mounting the
charger.
Description
Mounting hardware (not included)
No parts required
Upper handle assembly
Lower handle
Bolt (5/16 x 1-3/4 inches)
Flange locknut (5/16 inch)
Curved washer
No parts required
No parts required
No parts required
Charging the Battery
Qty.
2 Mount the battery charger (optional).
–
Remove the cable guard.
1
2
4 Assemble the lower handle.
4
8
–
Install the handle.
–
Install the cable guard.
–
Assemble the grass bag.
Slide the charger over the appropriately positioned
hardware to secure the charger in place (hardware
not included).
8
Use
Figure 3
g290534