Installing/Uninstalling Software; Installation Procedure - Canon imageCLASS MF4100 Series Starter Manual

Installing/Uninstalling Software

Installation Procedure

Before Installation:
• Do not connect the USB cable before installing the
software. If you connect the USB cable before
installing the software and the Found New Hardware
Wizard screen appears, click [Cancel] and
disconnect the USB cable.
• For Windows 2000/XP, log on as an Administrator to
install the software.
• Make sure the machine is turned on before
connecting the USB cable.
• On the screen shown at each step, click on the
circled button to proceed.
3
NOTE
If the disk space is insufficient to
install the software, an error
message is displayed. Free the
disk space, and then try again.
8 9
21
System Requirements
Microsoft Windows 98/98SE
® ®
CPU: Intel Pentium 90 MHz or higher
Memory: 128 MB or more
Microsoft Windows Me
® ®
CPU: Intel Pentium 150 MHz or higher
Memory: 128 MB or more
Microsoft Windows 2000
® ®
CPU: Intel Pentium 133 MHz or higher
Memory: 128 MB or more
Microsoft Windows XP (32-bit version)
® ® ®
CPU: Intel Pentium II/Celeron 300 MHz or
higher
Memory: 128 MB or more
4
10
1 2
5 6
11
If the MF4100 Series CD-
ROM Setup screen is not
displayed, click [start] on the
Windows task bar → [My
Computer] (Windows 98/Me/
2000: double-click [My
Computer] on the Windows
desktop). Open the CD-ROM
icon, then double-click [MInst]
([MInst.exe]).
7
12
22