Software Installation - Dynalink ISDN Quick Start Manual

English
IMPORTANT: Before installing the card, check the manual supplied with your
computer for specific instructions on the use of the expansion slots.
1. Remove the screws that secure the cover of the computer. See the manual of
the computer for the exact procedure. Remove the cover and set it aside.
2. Find an empty 32-bit PCI expansion slot for the card.
3. Remove the screw that secures the protective cover of the expansion slot.
Keep the screw at hand; you will need it again to secure the ISDN adapter.
4. Also keep the cover plate of the slot for future use.
5. Insert the card into the empty slot, contacts edge first. Press the card down
until it is firmly seated.
6. Secure the card using the screw you have kept for this purpose.
7. Close the computer case and replace and tighten the screws.
B: Installation of the PCMCIA ISDN Adapter
Place the PCMCIA Adapter in the notebook type II slot..

4. Software Installation

If you have an internal of PCMCIA Card and a system without USB support, please
use the \Nousb folder, which can be found in the folder of your operating system
(only for Windows 98 (SE)/Me/2000).
The names of the devices in the pictures may be slightly different from the
installation on your computer. This depends on the ISDN Adapter you are using.
19