dji Osmo Quick Start Manual

dji Osmo Quick Start Manual

Vehicle mount
Hide thumbs Also See for Osmo:

Advertisement

OSMO
Vehicle Mount
Quick Start Guide
V1.0

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Osmo and is the answer not in the manual?

Questions and answers

Summary of Contents for dji Osmo

  • Page 1 OSMO Vehicle Mount Quick Start Guide V1.0...
  • Page 2 The user shall observe safe and lawful practices including, but not limited to, those set forth in this document. Introduction The Vehicle Mount for the Osmo uses a triple suction cup design to secure the Osmo on any flat surface of a vehicle. Specifications Base Radius: 92 mm...
  • Page 3 Installation 1. Unfold the universal joint by loosening the knob. Screw it onto the base. Then, slide the base lock to the locked position. 2.  Place the Vehicle Mount on a flat surface such as the roof of your car.  Ensure the suction cups make good contact with the surface and then push down the suction cup levers.
  • Page 4 4. The suction cups may perform poorly in low temperature environments. DO NOT use the Vehicle Mount if it shows signs of looseness. 5. Bring the Osmo inside of the vehicle if you are travelling at speeds over 100 km/h. Otherwise, the gimbal may enter Protection mode and become inactive.

Table of Contents