Changing Settings; Reviewing Settings; Exit Remote Access; Audible Signals - AT&T 992 User Manual

9355_book_1ATT 7/12/99
ANSWERING SYSTEM OPERATION
At Cordless Handset or Touch Tone Phone

Changing Settings

1 Connect with the answering system.
Press * 9.
2
Press 9 to enter Setup Mode.
3
4
To change a setting (Select Announcement, Set Ring Select, Set
Audible Message Alert, Change Remote Access Code, Change Priority
Calling Code), press 4 or 6.
To save a setting, press 9.
5
Press 5 to exit the Setup Mode.
6

Reviewing Settings

1 Connect with the answering system.
Press 9. The system will announce the current settings.
2

Exit Remote Access

If you are using a touch tone phone, hang up the telephone. If you are
using the cordless handset, press a.

Audible Signals

Sound:
Long ringing
Single beep
Three-part tone
Repeating three-part tone
Two short beeps
Four short beeps
Four long beeps
Long buzzing tone
Series of ascending tones
"Chirp" after ring
36
2:25 PM Page 36
Meaning:
Incoming call
Valid button press
Page
Handset Locator
Handset is out of range
Low battery
Base is busy
Error – unsuccessful action
Action has been successful
Priority Call