NL Set up and connect
WARNING
Risk of injury!
When used on a plinth, the device can
tip over.
The device feet for commissioning
▶
on a plinth must be absolutely
with the fixings
→
Page 31 from the manufacturer
settle.
PAY ATTENTION!
The appliance may contain residual
water. If you tilt the appliance more
than 40°, residual water may leak out.
Carefully tilt the device.
▶
installation site
Plinth
Floor with wooden
beams
kitchen
14
To demand
The device with
locking lips
→ Page 31
confirm.
Place the device
guess at a
resistant
wooden plate (thick-
too minimal
30mm) which
screwed to the
floor.
The device al-
borrow under a
continuous work
place sheet,
that fixed with the
adjacent
cabinet is connected
Pine tree. Required
niche width:
60 cm.
installation site
on a wall
PAY ATTENTION!
Residual water can freeze. Freezing
residual water can damage the
appliance and frozen hoses can burst.
Do not place the device in areas
▶
prone to frost or outdoors.
4.4 Removing transport locks
The device is secured for transport
with transport locks at the rear of the
device.
Remark: Keep the screws of the
transport locks and the sleeves for
later transport
→ Page 55 .
Pull the hoses out of the holders.
1.
To demand
no snakes
between wall and
device clamping
man.