Vitek VT-8553 Manual Instruction page 4

ENGLISH
THIS UNIT IS INTENDED FOR HOUSEHOLD
USE ONLY. ITS COMMERCIAL USAGE AND
USAGE IN PRODUCTION AREAS AND WORK
SPACES IS PROHIBITED.
BEFORE THE FIRST USE
After the unit transportation or storage at
low temperature keep it for at least three
hours at room temperature before switch-
ing on.
Unpack the unit completely and remove any
–
promo-stickers that can prevent the unit
operation.
Check the unit for damages; in case of dam-
–
ages, do not use the unit.
Before switching on, make sure that the
–
operating voltage of the unit corresponds to
the voltage of your mains.
SWITCHING ON
Place the unit horizontally, turn the base (5)
–
counterclockwise «
Remove the filter (10) from the unit body
–
(3) (pic. 1).
Remove the filter (10) from the packaging
–
materials.
Install the filter (10) into the unit body (3)
–
(pic. 1).
Install the base (5) and turn it clockwise until
–
bumping « » (pic. 1).
Place the unit on a flat steady and dry sur-
–
face.
Connect the power plug to the mains
–
socket, you will hear a sound signal and the
operation mode indicators (6, 8) and the
illumination will light up. After 3 seconds
the unit will switch to the standby mode, the
operation mode indicators and the illumina-
tion will go out.
Switch the unit on by pressing the on/off
–
button (9) « », the power indicator (8) will
light up. The illumination will light up and the
second airflow speed will switch on with the
corresponding indicator (6).
Note:
the operation mode buttons on the control
–
panel (1) are touch-sensitive, you need only
to touch the button to switch the necessary
operation mode on.
To select the desired airflow speed of the
–
fan consequently press the button (7) «
IM VT-8553.indd 4
» and remove it (pic. 1).
»,
the airflow speed will change in a 2-3-1
sequence.
Notes:
when you switch the unit on, the built-in air
–
ionizer will switch on automatically.
the illumination will automatically switch off
–
when the unit switches to the first airflow
speed of the fan.
Note: - the HEPA filter (10) service life
depends on the filtered air. Using the air puri-
fier in a humid place will significantly reduce
the filter service life.
To switch the unit off press the on/off
–
button (9) « ». The unit will be switched
off, switch to the standby mode and the
indicators will go out, after that unplug
the unit.
The air purifier can operate for a long time,
–
but you have to follow the safety regula-
tions as during any other electric appliance
operation: unplug the unit when you don't
need to use it.
CLEANING THE UNIT
You can clean the HEPA filter with a soft
–
brush or a vacuum cleaner.
Caution!
Do not wash the HEPA filter. It must be
–
replaced after 3-6 months depending on
the air quality.
Regularly clean the grid (4) on the bottom
–
part of the unit body and the upper grid (2).
You can clean them with a household vac-
uum cleaner.
Wipe the unit body (3) with a slightly damp
–
cloth, and then wipe it dry.
Never immerse the unit into water or other
–
liquids.
Do not use abrasives and solvents to clean
–
the unit body (3).
STORAGE
•
Clean the unit body (3) before taking the
unit away for long storage.
• Keep the unit in a dry cool place out of
reach of children and disabled persons.
DELIVERY SET
Air purifier with the installed filter – 1 pc.
Instruction manual – 1 pc.
4
8/18/20 4:14 PM