Advertisement
DIAGRAM D
4-1244 Cartwright Street on Granville Island, Vancouver British Columbia Canada V6H 3R8 T (604) 681-8437 Toll Free 1 (888) 681-8437 Fax (604) 681-7282
7
ATTACHING SURF RUDDER THROUGH CASTING:
permanently attached to the stern of the kayak. Insert the rudder
pin through the "key hole". Rotate rudder 180º. See Diagram D.
Attach rudder cables with sister clips. Run the white haulcord for-
ward beside the cockpit. Slide bungee cord with hook through
webbing loop beside cockpit, with hook towards stern. Tie knot.
Clip haulcord slightly slack for easier rudder function.
8
CONNECTING RUDDER CONTROL TO FOOT BRACE
Red webbing adjusters are connected to the foot brace. Unscrew
thumb-knob on foot brace; stem of knob goes through grommet.
To make the adjuster shorter, fold webbing over to second grom-
met. Re-attach knob to foot brace. Slide brace on to track.
Ensure brace can slide easily on track. (If not, check knob that
you re-attached.)
Grommet
Thumb screw knob
9
CABLE LENGTH ADJUSTMENT
To shorten cable length, pull on tab of webbing with loop; to
lengthen, lift tab of ladder-lock buckle.
Ladder-lock buckle
Sister Clips (two of these clips are mounted
on each side of the rudder).
Fold over to shorten
Tab with loop
The rudder casting is
PAGE 2
Advertisement
