Getting Started
1. Open the Wireless LAN package
2. Connect the Network Media Receiver to the power mains (220V)
Connect the AC adapter (PCGA-AC10V) to the DC port of the Network Media
Receiver.
Connect the power cable to the AC adapter and then to the wall socket.
The Network Media Receiver can be positioned either vertically or horizontally.
•
For vertical installation: insert the table support (supplied) into the
Network Media Receiver.
•
For horizontal installation: attach the four adhesive spacers (supplied),
one at each corner.
3. Set up the remote control
Put the 2 AA batteries into their compartments.
4. Connect the Network Media Receiver to your television or VCR
Connect the A/V cable to the sockets on your TV or VCR.
5. Configure your Network environment
•
To use the connection to the Network Media Receiver in wireless mode (without cables) with the
VAIO: Go to WIRELESS SETUP - create your Wireless environment.
•
To connect the Network Media Receiver in Wired mode (with cable connected to the VAIO
Ethernet port): Connect the Network Media Receiver as described in WIRED SETUP - direct
connection (by cable).