Harman Kardon AVR35RDS User Manual page 15

NOTE: While most speaker manufacturers
adhere to an industry convention of using
black terminals for negative and red ones
for positive, some manufacturers may
vary from this configuration. To assure
proper phase, and optimal performance,
consult the identification plate on your
speaker, or the speaker's manual to verify
polarity. If you do not know the polarity
of your speaker, ask your dealer for
advice before proceeding, or consult
the speaker's manufacturer.
7. Connections to a subwoofer are made
via a line-level audio connection from
the
Subwoofer Output ¶
level input of a subwoofer with a built-in
amplifier. If a passive subwoofer is used,
the connection first goes to a power
amplifier, which will be connected to one
or more subwoofer speakers.
Video Equipment Connections
Video equipment is connected in a fashion
similar to audio components. Again, the
use of high-quality interconnect cables is
recommended to preserve signal quality.
1. Connect a VCR's audio and video
Play/Out jacks to the
Video 1 In
on the rear panel. The audio and
£
Record/Out jacks on the VCR should be
connected to the
Tape Monitor Out
jacks b on the AVR35RDS.
2. Connect the audio and video outputs
of a satellite receiver, cable TV converter
or television set or any other video source
to the jacks › .
Video 2 In
AVR35RDS 230 volt Rev (C) 9/28/98
Installation and Connections
3. Connect the audio and video outputs
of a DVD or laser disc player to the
jacks .
§
4. Connect the
jacks on the receiver to the video
input of your television monitor or
video projector.
System and Power Connections
The AVR35RDS is designed for flexible
use with external control components
and power amplifiers. These connections
are easy to make during an initial instal-
lation, or at a later date should you
to the line-
choose to upgrade your system.
Remote Control Extension
If the receiver is placed behind a solid or
smoked glass cabinet door, the obstruc-
tion may prevent the remote sensor from
receiving commands. In this event, an
optional remote sensor may be used.
Connect the output of the remote sensor
to the
Remote Cont. In
If other components are also prevented
from receiving remote commands, only
one sensor is needed. They may use this
jacks
unit's sensor or a remote eye by running
a connection from the
jack to the Remote In jack on
·
Out
Harman Kardon or other compatible
equipment.
15
DVD
TV Monitor Out fi
jack .
°
Remote Cont.
AC Power Connections
This unit is equipped with two accessory
AC outlets. They may be used to power
accessory devices, but they should not be
used with high-current draw equipment
such as power amplifiers. The total power
draw may not exceed 50W to each outlet.
The Switched ⁄ outlet will receive
power only when the unit is on. This is
recommended for devices that have no
power switch, or a mechanical power
switch that may be left in the "ON"
position.
NOTE: Devices with electronic power
switches may only go into a Standby
mode when plugged in here.
The outlet will receive
Unswitched ¤
power as long as the unit is plugged into
a powered AC outlet.
Finally, when all connections are com-
plete, plug the power cord into a non-
switched 120-volt AC wall outlet. You're
almost ready to enjoy the AVR35RDS!