Since the use of this information, the equipment connected and the conditions by which any JAR Systems product is used is beyond the control of JAR Systems, it is the obligation of the owner and/or user to determine the correct and safe use of any equipment and product.
.391 a maximum drywall thickness of 5/8” (1.6cm). Always ensure that proper hardware is used for the wall surface type. Never operate this mounting .688 system if it is damaged. Contact JAR Systems for replacement or repair. (13.27) (22.11) (11.66)
— Essential Charging Station Owner’s Manual Version E Position #1 Position #2 ack side Position #1 e screws Position #2 Position #2 Reversible Power Strip (AC stations only) Install the Power Strip (AC stations only) F. The power strip can be mounted on either the front G.
Essential Charging Station Mount the Tray to the Chassis I. Rest the tray on the tabs near the front of the chassis. Insert 4 [B2] screws with plastic washers H. Pull out the sides of the chassis to the depth through the chassis and into the back side of the needed for your device.
— Essential Charging Station Owner’s Manual Version E Install the Top Security Bar (Optional) tray lid shut using the screw and washer that were removed in step A and the Torx key. P. For security, place the top locking bar at the lowest height that will fit over the devices.
In this case it may be best to arrange most of the adapters as far back in the tray as possible from left to right, flipping about half on their side. Contact JAR Systems for additional assistance. W. After AC adapters are arranged in the tray, plug them into the power strip.
Do not connect unsupported items to the charging cart or use for any purpose other than its intended use. This warranty does not cover, and JAR Systems, LLC will not be responsible for, any damages due to loss of use of...