Makita DTS131 Instruction Manual page 7
Cordless oil-pulse driver
Hide thumbs
Also See for DTS131:
- Instruction manual (73 pages) ,
- Instruction manual (12 pages) ,
- Instruction manual (40 pages)
Table of Contents
Advertisement
Switch action
CAUTION:
•
Before inserting the battery cartridge into the
tool, always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released.
1
► 1 . Switch trigger
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
NOTE:
•
The tool automatically stops if you keep pulling
the switch trigger for about 360 seconds.
Lighting up the front lamp
CAUTION:
•
Do not look in the light or see the source of light
directly.
1
► 1 . Lamp
► 1 . Button
To turn on the lamp status, press the button
seconds. To turn off the lamp status, press the but-
ton
for few seconds again.
With the lamp status ON, pull the switch trigger to turn on
the lamp. To turn off, release it. The lamp goes out approx-
imately 10 seconds after releasing the switch trigger.
With the lamp status OFF, the lamp will not turn on even
if the trigger is pulled.
NOTE:
•
To confirm the lamp status, pull the trigger. When the lamp
lights up by pulling the switch trigger, the lamp status is ON.
When the lamp does not come on, the lamp status is OFF.
•
While pulling the switch trigger, the lamp status
cannot be changed.
•
For approximately 10 seconds after releasing the
switch trigger, the lamp status can be changed.
Reversing switch action
CAUTION:
•
Always check the direction of rotation before operation.
•
Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of rota-
tion before the tool stops may damage the tool.
•
When not operating the tool, always set the
reversing switch lever to the neutral position.
A
► 1 . Reversing switch lever
This tool has a reversing switch to change the direction of rota-
tion. Depress the reversing switch lever from the A side for clock-
wise rotation or from the B side for counterclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
7 ENGLISH
1
1
1
for few
B
Advertisement
Table of Contents
