Mounting The Housing - Smoke Guard M200 Installation Manual

Doc #2401 – M200/M400 Installation Manual
4.2 – Mounting the Housing
Required parts, tools, and hardware:
• Housing (dust cover and screen assembly removed per section 3.2)
• Machine screws (originally removed per section 3.2)
• 5/32" ball head hex wrench
Installing the mounting plate:
1. Lift the housing onto the mounting plate, hooking the lip at the top of the housing over the plate
2. Adjust the position of the housing so the center mark inside the housing aligns with the center of the
elevator frame
3. Verify that the slots in the back of the housing line up with the threaded standoffs on the mounting plate
4. Fasten the housing to the mounting plate using the machine screws into the threaded standoffs
Rev. 9
12