Preparing The Housing For Mounting - Smoke Guard M200 Installation Manual

Doc #2401 – M200/M400 Installation Manual
3.2 – Preparing the Housing for Mounting
The screen assembly ships inside the housing, remove carefully to avoid damaging the screen and/or the
housing components.
NOTE: The door closer extension springs (M400 only) and the up-limit switch are not attached in their
operating positions as shipped. This allows for safe removal of the screen assembly. They will be installed to
their final location later in the installation process.
Removing the screen and mounting plate from the housing:
1. With the housing return side on the saw horses, remove the dust cover
2. Push the door open and gently roll the screen out through the housing door
3. Using the 5/32" hex wrench loosen and remove the machine screws holding the mounting plate to the
housing and remove the mounting plate
Rev. 9
10