Code Listings And Procedures
(Allison 4
P063F
Auto
Configuration
Engine
Coolant Not
Present
P0658, P0659,
P2670, P2671,
P2685, P2686
Actuator
Supply
Voltage Fault
P0701
Transmission
Control
System
Performance
P0702
Transmission
Control
System
Electrical
th
Generation Controls) (cont'd)
1. Check:
a. Data link communication connectors at engine and
transmission controllers are tight, clean, and
undamaged.
b. Data link communications wiring harness has no
opens, shorts, or shorts-to-ground.
— The resistance between J1939 CAN high and
CAN low wires should be 60 Ohms.
c. Engine coolant temp sensor harness for opens and
shorts.
1. Check:
a. Main transmission connector is tight, clean, and
undamaged.
b. TCM connector is tight, clean, and undamaged.
c. Wiring harness has no opens, shorts-between-wires,
or shorts-to-ground.
1. Let the vehicle idle with parking brake applied, wheels
chocked, and vehicle level. Check:
a. Correct dipstick installed.
b. Correct fluid level.
2. Check:
a. Main transmission connector is tight, clean, and
undamaged.
b. TCM connector is tight, clean, and undamaged.
c. Wiring harness has no opens, shorts-between-wires,
or shorts-to-ground.
1. Check:
a. Main transmission connector is tight, clean, and
undamaged.
b. TCM connector is tight, clean, and undamaged.
c. Wiring harness has no opens, shorts-between-wires,
or shorts-to-ground.
75