Before Fi Rst Use; Charging The Battery; Assembly - Westfalia 01406 Operating Instructions Manual

Before fi rst use
• Before using the device, remove all transport protection or advertising. Never re-
move the type plate or any warnings!
• Charge the battery (see the chapter, "Charging the battery").
• Remove coarse dirt from the fl oors and surfaces you want to clean.

Charging the battery

PLEASE NOTE!
■ Short-circuit hazard! Do not insert conductive objects (such as a screwdriver) in the
charging socket.
■ Remove the charging adapter from the outlet when the device is not being charged.
■ The battery must be fully charged before powering on for the fi rst time so that
the maximum charge capacity can be obtained. It takes between 10 and 12
hours to charge the device for the fi rst time.
1. Remove the silicone plug from the charging socket (16) on the motor unit (2).
2. Insert the coaxial plug of the charging adapter into the charging socket.
3. Insert the charging adapter into a properly installed, easily accessible wall outlet. The
indicator lights (13) will light up one by one.
4. Charge the battery for around 5 hours. The indicator lights will go out when the bat-
tery is fully charged.
5. Unplug the charging adapter from the mains fi rst, and then from the device.
6. Reinsert the silicone plug into the charging socket.

Assembly

The motor unit (2) can be used as a handheld device as well as with the telescopic rod (9).
Attaching / removing the telescopic rod
• Insert the motor unit into the frame (7). The safety catch must audibly lock into place
on the right and left. Check to make sure that it is securely in place.
• To remove the motor unit, press the safety catch outwards. This will release the motor
unit so it can be detached.
Attaching / removing the adapter plates
• The motor unit (2) contains 6 magnets (15) on its underside. The adapter plates can
be attached to these magnets. Simply select the adapter plate you want to use and
place it on the motor unit. When doing this, make sure the arrows on the motor unit
and the adapter plate are placed over one another and point towards each other.
• To remove the adapter plate, simply pull it from the motor unit.
Attaching / removing the cloths
• Select the cloth you want to use and attach it to the corresponding adapter plate with
the hook-and-loop fastener.
• To remove the cloth, hold the adapter plate and pull the cloth off .
01406_DE-EN-FR-NL_A5_V3.indb 17 01406_DE-EN-FR-NL_A5_V3.indb 17
17 EN
06.01.2020 16:03:10 06.01.2020 16:03:10