Advertisement
PowerPack 2000S
Manual for Installation and Operation
The Solar Water Pumping Company
l
a
INPUT AC
WARNING!
Electric shock hazard, dangerous
Voltage range
200-240 V ±10%
O
voltages and currents.
Max. current
16 A
No user-serviceable parts inside.
Frequency
47-63 Hz
INPUT DC
Before opening the cover, read
Max. PV voltage for PS2-1800
200 V
instruction manual for proper
Max. PV voltage for PS2-600
150 V
installation and operation.
OUTPUT DC
Rated voltage
up to 200/150 V
Rated current
12-14 A
OPERATING CONDITIONS
Operating temperature (ambient)
–20 to +45 °C
Advertisement
Table of Contents
Related Manuals for Lorentz PowerPack PP2000S
Summary of Contents for Lorentz PowerPack PP2000S
- Page 1 PowerPack 2000S Manual for Installation and Operation INPUT AC WARNING! Electric shock hazard, dangerous Voltage range 200-240 V ±10% voltages and currents. Max. current 16 A No user-serviceable parts inside. Frequency 47-63 Hz INPUT DC Before opening the cover, read Max.
-
Page 2: Safety Instructions
All work on the equipment should be done Thank you for purchasing a LORENTZ product. including the following: maintenance, inspection and installation must when it is not being operated and ideally electrically be fully qualified and trained. -
Page 3: Specifications
3 Specifications 4 Application Table 1: Specifications The LORENTZ PowerPack 2000S allows the pump to If PV is disconnected, a separate timer switch can be powered by an AC power supply from the grid or a be used to control the AC power supply to the generator. - Page 4 DC output of the PowerPack. Voltage Description selection voltage value The PP2000S allows 24/7 operation of the LORENTZ Pos 1. 135 V Mandatory position PS2-1800 / PS2-600 pump systems by connecting the Figure 4: PumpScanner feature settings and 24/7 operation configuration...
-
Page 5: Installation
PP2000S must be 1 mm² (AWG18) or larger. electrical load to the PV generator other Every solar pump system must be equipped with than the LORENTZ pump controller and a properly sized DC disconnect switch. The switch PowerPack. Connecting the battery... -
Page 6: Operation
Operation Troubleshooting 6 Operation 8 Troubleshooting Connect the AC power source and switch on the Before contacting service personnel with PowerPack AFTER it has been connected to the pump troubleshoorting questions, please follow the steps controller. When the controller and the PowerPack outlined in table 4. - Page 7 Sun. Water. Life. www.lorentz.de...
Need help?
Do you have a question about the PowerPack PP2000S and is the answer not in the manual?
Questions and answers