Related Manuals for Lorentz PowerPack 600S
Summary of Contents for Lorentz PowerPack 600S
- Page 1 PowerPack 600S Manual for Installation and Operation The Solar Water Pumping Company...
-
Page 2: Safety Instructions
Introduction 1 Introduction When installing and using this electrical equipment, basic safety precautions Thank you for purchasing a LORENTZ should always be followed, including the product. following: Before you begin – Please check the product label to verify that this is the item you ordered. - Page 3 Introduction Personnel qualification and training The accident prevention regulations must - All personnel for the operation, mainte- be observed. All work on the equipment nance, inspection and installation must should be done when it is not being be fully qualified and trained. Responsi- operated and ideally electrically isolated.
-
Page 4: Specifications
The pump in some applications. LORENTZ PowerPack PP600S allows the pump to be powered by an AC mains supply such as a grid or generator.* 3.2 Which Powerpack should be used? -
Page 5: Installation
A PV disconnect switch matching all bottom of enclosure. requirements above can be purchased WARNING – Mount the Power- from LORENTZ. Pack close to the pump con- troller, in a vertical position. Protect the unit from direct CAUTION - The use of a properly rainfall. -
Page 6: Wiring And Operation
CAUTION – Do not connect any electrical load to the PV gener- PS2-600 150 V DC ator other than the LORENTZ pump controller and Power- Select the wire that will fit to your grid Pack. Connection of battery connection socket and connect it to the charger, active solar tracker PowerPack. -
Page 7: System Layout
System Layout Figure 1: System layout (example) AC mains supply PowerPack 600S PS2-600 controller (grid or generator) PV generator PV disconnect submersible pump... - Page 8 www.lorentz.de...
Need help?
Do you have a question about the PowerPack 600S and is the answer not in the manual?
Questions and answers