Subscribe to Our Youtube Channel
Related Manuals for Lorentz PowerPack 2000S
Summary of Contents for Lorentz PowerPack 2000S
- Page 1 PowerPack 2000S DC power supply for PS2-1800 and PS2-600 pump systems Manual for Installation and Operation The Solar Water Pumping Company...
-
Page 2: Table Of Contents
We, BERNT LORENTZ GmbH, declare under our sole Declaration of conformity ..............3... -
Page 3: Safety Instructions
Local accident prevention regulations must be Scope of delivery of the PowerPack 2000S: personnel/operators and should be available at observed. All work on the equipment should be WARNING –... -
Page 4: Product Description
AC circuit breakers. An AC breaker at the Item No. 19-001057 PowerPack input must be installed. The AC breaker The PowerPack 2000S can be used as a continuous must meet local regulations. Pump Systems PS2-1800 / PS2-600 power supply, in conjunction with PV Modules or as a... -
Page 5: Installation
Sun Sensor Table 3: Product dimensions 11.1 Mounting Length The PowerPack 2000S should be mounted on a wall unit or panel close to the pump controller in a vertical AC mains supply position. The unit must be protected from direct 13.8... -
Page 6: Voltage Selection
Figure 6: Voltage switch selector. Setting for PS2-600 in position 1 Figure 7: PP2000S cable glands The PowerPack 2000S is delivered pre-configured from the factory to work with PS2-1800 systems, so the voltage switch selector will default to position 4 as shown in "Figure 5". -
Page 7: Electrical Connections
PV generator other ƒ DC power out - Connect the "DC power out" of than the LORENTZ pump controller and Refer to "Figure 9: Wiring terminals of the PP2000S" the PowerPack unit to the POWER IN (+ -) terminals on page 13 and "Figure 10: Terminal wiring... -
Page 8: Remote On/Off Function (Optional)
PS2-600 configure automatic switching of the power supply Controller The PP2000S allows 24/7 operation of the LORENTZ between solar and grid power navigate to “Feature PS2-1800 / PS2-600 pump systems by connecting the Settings” in PumpScanner and expand the “Activate... -
Page 9: Operation
Operation Troubleshooting 12 Operation 14 Troubleshooting Before contacting service personnel with troubleshoorting questions, please follow the steps 12.1 Running on AC Under the tab “Sun Sensor is triggered”, select “24/7 outlined below. operation with PowerPack”. Define the irradiation threshold for which the PowerPack should be After the DC output of PowerPack has been Table 7: Troubleshooting guide activated. - Page 10 1993 LORENTZ has pioneered, innovated and excelled in the engineering and manufacturing of solar powered water pumping. Today LORENTZ is active in over 130 countries through a dedicated network of professional partners. LORENTZ technology uses the power of the...
Need help?
Do you have a question about the PowerPack 2000S and is the answer not in the manual?
Questions and answers