Table of Contents
Advertisement
Preparation
Install Display on solid horizontal surface such as a table or desk.
For ventilation, leave a space of at least 10 cm free all around the set. To prevent any fault
and unsafe situations, please do not place any objects on top of the set.
Installation of device on the wall (Wall Bracket Optional Extra)
Step1:
Invert the flat monitor screen and placed it on a flat surface. Remove the back support from
the screen. Replace the support with the mounting bracket align the holes from the bracket
with the mounting holes found on the back of the monitor chassis. Secure the bracket with
the same four (4) 4 (mm) head screws.
Step 2:
Choose the wall where the monitor would be located. Level and mark with a pencil the four
(4) mounting points found on the wall bracket. Drill pilot holes for the plastic anchors then
secure the wall bracket with the four (4) L=32 mm x D=5 mm screws (supplied).
Step 3:
Raise the monitor with the mounting bracket attached and slip the top opening to the safety
flange on the secured wall bracket. Let the monitor fall in place safely and secure the two (2)
D=4 mm x L=10 mm safety screws (supplied) with a long screwdriver for additional security.
Note: Do not over tighten!
All manuals and user guides at all-guides.com
- 4 -
"When the wall bracket is used to in-
stall the back cover and the front panel
after the foot assembly is removed, to
eliminate the space which occurs at
the lower side of the front cover (front
panel) and back cover, use the screws
that are supplied for the lower side of
the foot top cover (back support)."
Advertisement
Table of Contents
