Before Switching On Your Tv; Power Connection; Connections To The Aerial Socket; How To Connect Other Devices - Hitachi 15LD2200 Instructions For Use Manual

Before Switching On Your TV

Power Connection

8Ãhqhƒ‡r…
IMPORTANT: The TV set is designed to op-
erate on 12 V DC. For this, an adaptor is
used which gives 12V DC voltage. Connect
this adaptor to a system that supplies 220-
240 V AC, 50 Hz.
• After unpacking, allow the TV set to reach the
ambient room temperature before you con-
nect the set to the mains.

Connections to the Aerial socket

6U@GGDU@ÃS@8@DW@S

+)8+)
WÃS@6SÃQ6I@G
• Connect the aerial or cable TV plug to the
aerial socket located at the rear of the TV
and connect the cable plug coming out from
the TV out socket located on the devices
(VCR, DVB etc.) to this socket as well.

How To Connect Other Devices

IMPORTANT: Switch off the TV before con-
necting any external device.
Sockets for external connections are at the
rear side of the TV. For connection of other
devices via SCART refer to the manuals of
the related devices.
All manuals and user guides at all-guides.com
‚ÃQPX@S
DIQV Ã98Ã !ÃW
‡r…€vhy
67G@ÃUWÃ
Inserting Batteries In The Remote
Control Handset
• Remove the battery cover located on the
back of the handset by gently pulling up-
wards from the indicated part.
• Insert two AAA (R03) or equivalent type of
batteries inside.
• Replace the battery cover.
NOTE: Remove the batteries from remote
control handset when it is not to be used for
a long period.Otherwise it can be damaged
due to any leakage of batteries.

Switching The TV ON/OFF

To switch the TV on:

Your TV will switch on in two steps:
1- Connect the power supply cord to the sys-
tem. Press the “ ” (POWER) button at the
top of the TV. Then the TV switches itself to
stand-by mode and the led becomes red
located on the front of the TV.
2- To switch on the TV from stand-by mode
either:
Press a digit button on the remote control so
that a programme number is selected,
or,
Press “-P/Ch” or "P/Ch+” button at the top of
the TV or press “-P/CH” or “P/CH+” button on
the remote control, so that last switched off
programme is selected.
Either way the TV will switch on and the LED
becomes green.
- 9 -