Page 3
DD1709675 P1313 – Rev 2 1 April 2011 Please fill in the information below to use for reference when calling Daktronics for assistance. Display Serial No. _______________________________________________________ Display Model No. _______________________________________________________ Date Installed ___________________________________________________________ DAKTRONICS, INC. Copyright 2009-2011 All rights reserved. While every precaution has been taken in the preparation of this manual, the publisher assumes no responsibility for errors or omissions.
Figure 1: Daktronics Drawing Label Reference Drawing: System Riser Diagram ................Drawing C-325405 Daktronics identifies manuals by the DD or ED number located on the cover page of each manual. For example, this manual would be referred to as DD1709675. Introduction...
Figure 3: Typical Label Power or signal plug for the opposite jack Following the Replacement Parts List is the Daktronics Exchange Policy and the Repair & Return Program. Refer to these instructions if replacing or repairing any display component. Introduction...
Dimensions: Height, Width Model Weight Watts Volts Amps (including padding), & Depth ST-2002 H 3'0" x W 8'5" x D 3'4" 185 lb 1440 W 120 V AC* 12 A (914mm, 2565mm, 1016mm) (84 kg) ST-2003 H 3'0" x W 8'5" x D 3'4"...
Page 10
b. Turn the metal hook clockwise to give the latch a tighter fit, or turn the metal hook counterclockwise to give the latch a looser fit. Make sure the metal hook is pointing downward and then tighten the nut. Lift the table surface approximately 90 degrees and swing the side legs out and into place underneath.
Disconnect power when not using the display. Display Information Daktronics backlit scorer‟s tables occasionally require replacement of failed lamps or ballasts. Refer to Drawings B-381209 and B-381575 in Appendix A for detailed wiring schematics and refer to Section 3.6 for replacement part numbers.
Following the wire chart on the ballast, and using the color code of the existing wires from the previous ballast (from Step 4), use the wire-nuts to connect the wires from the lamps to the ballast wires. Call Daktronics customer service before continuing if there is an inconsistency.
In most circumstances, the replacement part will be invoiced at the time it is shipped. If the failed part or replacement part is not returned to Daktronics within 3 weeks of the ship date, Daktronics will assume that the customer is purchasing the replacement part and will send an invoice for the value of the new sale part.
Repair & Return Program For items not subject to exchange, Daktronics offers a Repair & Return Program. To send a part for repair, follow these steps: Call or fax Daktronics Customer Service: Refer to the appropriate market number in the chart listed on the previous page.
Page 20
POSS HOME GUEST HOME GUEST PERIOD PERIOD...
Page 21
Appendix B: Daktronics Warranty and Limitation of Liability Daktronics Warranty and Limitation of Liability...
Page 23
WARRANTY AND LIMITATION OF LIABILITY This Warranty and Limitation of Liability (the “Warranty”) sets forth the warranty provided by Daktronics with respect to the Equipment. By accepting delivery of the Equipment, Purchaser agrees to be bound by and accept these terms and conditions. Unless otherwise defined herein, all terms within the Warranty shall have the same meaning and definition as provided elsewhere in the Agreement.
Page 24
In no event shall Daktronics be liable to Purchaser or any other party for loss, damage, or injury of any kind or nature arising out of or in connection with this Warranty in excess of the purchase price of the Equipment actually delivered to and paid for by the Purchaser. The Purchaser’s remedy in any dispute under this Warranty shall be ultimately limited to the Purchase Price of the Equipment to the extent the Purchase Price has been paid.