Advertisement
Quick Links
Operation Manual
Hang-on Aquarium Filter
51649, 51650
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Related Manuals for SunSun CBG-500
Summary of Contents for SunSun CBG-500
- Page 1 Operation Manual Hang-on Aquarium Filter 51649, 51650 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignificantly. Updating the documentation If you have suggestions for improvement or have found any irregularities, please contact us.
- Page 2 The information contained in this document may alter at any time without previous notice. It is prohibited to copy or spread any parts of this document in any way without prior written allowance. All rights re- served. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 Introduction Thank you for purchasing this quality product. To minimize the risk of injury we urge that our clients take some basic safety precautions when using this device. Please read the operation instruc- tions carefully and make sure you have understood its content. Keep these operation instructions safe.
- Page 4 ◦ Use the device in water with temperatures between 4 ℃ and 35 ℃ (39 °F to 95 °F). ◦ Only use the device in aquariums. ◦ Do not use the device with liquids other than water, e.g., dangerous or explosive liquids. ◦...
- Page 5 Assembly 1. Take out the filter from the packaging, wash the filter pads, carbons and ceramic balls. 2. Put the telescopic tube and intake cover into the intake tube. © by WilTec Wildanger Technik GmbH Item 51649, 51650 Page 5 http://www.WilTec.de http://www.aoyue.eu 2021-1...
- Page 6 3. Put the filter pads, carbons and ceramic balls into the filter body (fig. 3-1). Adjust the filter to glass holder so the filter is horizontal (fig. 3-2). 4. Fill the filter body with tank water before usage. Plug in the power plug. ©...
- Page 7 5. Adjust the water flow dial to limit the water intake. The lateral regulator can adjust the intake for the surface skimmer. Turn the suction rate if your surface skimmer sucks in too much air. 6. The UV sterilizer can be turn on and off if needed. Maintenance and cleaning 1.
-
Page 8: Troubleshooting
Technical data UV power Pump Suitable for aquari- Item № ℓ ⁄ Model Flow rate ( power (W) ums (ℓ) CBG-500 51649 38–115 CBG-800 51650 75–190 Troubleshooting Problem Cause Solution Dirty water Beneficial bacteria not established in the Dose some bacteria into the filter and new filter. - Page 9 Disposal regulations EU guidelines regarding the disposal of scrap electric appliances (WEEE, 2012/19/EU) were imple- mented in the law related to electrical and electronic equipment and appliances. All WilTec electric devices that fall under the WEEE regulations are labelled with the crossed-out wheeled waste bin logo.