Table of Contents
Advertisement
Cleaning and Maintenance
Cooktop Surfaces
Several different finishes have been used in your cooktop. Cleaning in-
structions for each surface are given below. NEVER USE AMMONIA,
STEEL WOOL PADS OR ANY ABRASIVE CLOTHS AND MATERIALS
SUCH AS CLEANSERS, OVEN CLEANERS, OR ABRASIVE POWDERS.
THEY CAN PERMANENTLY DAMAGE YOUR COOKTOP.
Control Panel
DO NOT use any cleaners containing ammonia, abrasives or stainless
steel cleaners on any surface that contains graphics. These products
could remove the graphics from the control panel. Apply hot, soapy
water to a soft clean cloth. DO NOT spray liquids directly onto the con-
trol panel.
Control Knobs
MAKE SURE ALL CONTROL KNOBS POINT TO THE "OFF" POSITION
BEFORE REMOVING. Pull the knobs straight off. Wash in detergent and
warm water. Dry completely and replace by pushing firmly onto stem.
Stainless Steel Parts
All stainless steel body parts should be wiped regularly with hot, soapy
water at the end of each cooling period and with a liquid cleaner designed
for that material when soapy water will not do the job. DO NOT use steel
wool, abrasive cloths, cleansers, or powders. If necessary, scrape stainless
steel to remove encrusted materials, soak the area with hot towels to
loosen the material, then use a wooden or nylon spatula or scraper. DO
NOT use a metal knife, spatula, or any other metal tool to scrape stainless
steel. DO NOT permit citrus or tomato juice to remain on stainless steel
surface, as citric acid will permanently discolor stainless steel. Wipe up any
spills immediately.
CAUTION
To avoid the risk of property damage, DO NOT USE BRASS CLEAN-
ERS OR ABRASIVE CLEANERS ON ANY BRASS PARTS. All brass
body parts should be wiped regularly with hot, soapy water and a soft,
clean cloth. When hot, soapy water will not do the job, use every day
household cleaners that are not abrasive.
Brass Parts
All special ordered brass parts are coated with an epoxy coating.
20
All manuals and user guides at all-guides.com
Troubleshooting
Number of Flashes
Possible Cause and/or Remedy
1 with brief pause
Internal power device over temperature.
Contact service.
3 with brief pause
Internal power device malfunction. Contact service.
5 with brief pause
Power device temperature sensor malfunction.
Contact Service.
6 with brief pause
Coil temperature sensor malfunction.
8 with brief pause
Inside ambient temperature too high.
9 with brief pause
Incompatible cookware for induction.
Material Compatibility Detector
If the pan's material or it's dimensions are not suitable, the pan indicator
will flash and the unit will not cycle on.
Small Object Detector
The induction cooktop will not recognize any object or utensil smaller
than 2 inches in diameter. For best results, use pans that are between
5" (13 cm) and 12" (31 cm) in diameter.
21
Advertisement
Table of Contents
