Upgrading The Firmware - Axis 1610 User Manual

Section 5: Upgrading the Firmware
50
Section 5
Upgrading over the
Network using FTP

Upgrading the Firmware

You can upgrade the AXIS 1610 firmware in the flash memory
using one of the following methods:
• FTP (TCP/IP)
• AXIS NetPilot Upgrade Wizard (IPX/SPX)
Note: ❏ Updating instructions are also supplied with the software update.
To upgrade over the network using FTP you will need the file
with the new print server software. The name of this file is in the
form
product_version.bin
release 5.80. You can download the print server software from
the Axis web site at http://www.axis.com
Note:
❏ You must assign the AXIS 1610 with an IP address, as described
in Assigning an IP address, on page 22, before you can use this
upgrading method.
Follow the procedures below to upgrade the AXIS 1610:
1. Log in to the AXIS 1610 with the command:
ftp <host name>, or ftp <IP address>
2. You will be prompted for user id and password.
Default user id:
Default password:
3. To change to binary transfer mode, type the command:
binary
4. Type the command:
put <software name> flash
(
<software name>
e.g.
1610_580.bin)
AXIS 1610 User's Manual
, e.g.
1610_580.bin
root
pass
is the name of the new print server software,
for software