Advertisement
For Instruction to http://www.philio-tech.com
DANGER
Danger of electrocution!
All works on the device may be performed only by a qualified and licensed elec-
trician. Observe national regulations.
Any works introducing changes into the configuration must be always per-
formed with disconnected voltage.
Choosing a Suitable Location
1. Do not locate the Module facing direct sunlight, humid or dusty place.
2. The suitable ambient temperature for the Module is 0°C~40°C.
3. Do not locate the Module where exists combustible substances or any
source of heat, e.g. fires, radiators, boiler etc.
4. After putting it into use, the body of Module will become a little bit hot of
which phenomenon is normal.
Adding to Z-Wave
TM
Network
In the front casing, there is an on/off button with LED indicator below which is used to
toggle switch on and off or carries out inclusion, exclusion, reset or association. When
first power is applied, its LED flashes on and off alternately and repeatedly at 2 second
intervals. It implies that it has not been assigned a node ID.
The table below lists an operation summary of basic Z-Wave functions. Please refer to
the instructions for your Z-Wave
TM
function, and to
include/exclude/reset
Warning:
1.Plug out to disconnect from power supply; Do not plug in line.
2. Do not exceed the max rating.
Function
Description
No node ID
The Z-Wave Controller does not al-
locate a node ID to the Switch.
1.Have Z-Wave Controller en-
Add
tered inclusion mode.
2.Pressing On/Off button three
times within 2 seconds will enter
inclusion mode.
Certificated Primary Controller to access the Setup
devices
Annotation
LED 2-second on, 2-second
off
One press one flash
To support handling of the
device when already installed
the external switch can be
used for inclusion or exclusion
for 3 minutes after power up.
Advertisement
