babcockdavis Lume-A-Lit BEM-SNE Installation, Operation And Maintenance Manual

Lume-A-Lite™ NYC COMPLIANT NOT AN EXIT SIGN
Model(s): BEM-SNE
GENERAL DESCRIPTION
Introduction + Safety
Please read the complete instructions carefully before beginning any work. To ensure proper
installation and performance of the product, the following actions must be completed by the
installing contractor. Failure to do so will affect product warranty.
GENERAL SAFETY PRECAUTIONS
is solely the responsibility of the user, through its own analysis to select products suitable for their specific application
requirements, ensure they are properly maintained, and limit their use to its intended purpose. Follow proper local,
state and federal regulations for proper installation and operation requirements.
Transportation + Storage
o Inspect all shipments and materials for missing or damaged components and hardware.
o Material must be stored in a clean, dry location.
Preparation
o The temperature of the product being installed and the surface it is being installed on must
be at least 60 degrees.
o Surfaces must be clean, smooth, and non-porous. Install a sample piece of the tape material
for 24 hours on the application surface to ensure that the tape adheres properly before
doing a complete project installation.
Photoluminescent egress path marking systems are an
important life safety requirement in current building
codes. These systems allow for the safe and quick
evacuation of buildings in the case of an emergency.
They provide a routing system that is not dependent
on electrical power that can easily be followed in dark
and smoke-filled exit pathways.
Improper selection, installation, or use can cause personal injury or property damage. It
Installation, Operation
+ Maintenance Manual
©2020 Babcock-Davis, Inc.
1
Rev 8/2020