Advertisement
Quick Links
Lume-A-Lite™ EXIT SIGNS
Model(s): BEM-SLE100/BEM-SE100
GENERAL DESCRIPTION
Introduction + Safety
Please read the complete instructions carefully before beginning any work. To ensure proper
installation and performance of the product, the following actions must be completed by the
installing contractor. Failure to do so will affect product warranty.
GENERAL SAFETY PRECAUTIONS
is solely the responsibility of the user, through its own analysis to select products suitable for their specific application
requirements, ensure they are properly maintained, and limit their use to its intended purpose. Follow proper local,
state and federal regulations for proper installation and operation requirements.
Transportation + Storage
o Inspect all shipments and materials for missing or damaged components and hardware.
o Material must be stored in a clean, dry location.
Preparation
o These signs are for interior use only and are suitable for a temperature range of +50 to 100
degrees Fahrenheit.
These signs are rated for a visibility of 100 feet when activated by a minimum five (5) foot-
o
candlelight source and can be used in both high-level and low-level applications.
Photoluminescent egress path marking systems are an
important life safety requirement in current building
codes. These systems allow for the safe and quick
evacuation of buildings in the case of an emergency.
They provide a routing system that is not dependent
on electrical power that can easily be followed in dark
and smoke-filled exit pathways.
Improper selection, installation, or use can cause personal injury or property damage. It
Installation, Operation
+ Maintenance Manual
©2020 Babcock-Davis, Inc.
1
Rev 8/2020
Advertisement
Related Manuals for babcockdavis Lume-A-Lite BEM-SLE100
Summary of Contents for babcockdavis Lume-A-Lite BEM-SLE100
- Page 1 Installation, Operation + Maintenance Manual Lume-A-Lite™ EXIT SIGNS Model(s): BEM-SLE100/BEM-SE100 GENERAL DESCRIPTION Photoluminescent egress path marking systems are an important life safety requirement in current building codes. These systems allow for the safe and quick evacuation of buildings in the case of an emergency. They provide a routing system that is not dependent on electrical power that can easily be followed in dark and smoke-filled exit pathways.
- Page 2 Installation, Operation & Maintenance Lume-A-Lite™ EXIT SIGNS Model(s): BEM-SLE100/BEM-SE100 Note: o When installing into drywall or concrete block, use expansion sets to ensure a firm grip. o It is prudent to confirm that the mounting bracket location on the wall or ceiling is appropriate (i.e. provides adequate clearances between assembled exit sign and other objects, such as walls, ceiling, or swinging doors) by holding the assembled exit sign in the mounting bracket and holding the bracket in the desired location on the wall or ceiling.
- Page 3 Installation, Operation & Maintenance Lume-A-Lite™ EXIT SIGNS Model(s): BEM-SLE100/BEM-SE100 Projection Wall Mount – One or Two-Sided Installation The photoluminescent exit sign shall be placed above doors through which occupants must pass to complete the exit path. 1. Mark pilot hole locations on wall using mounting holes in mounting bracket. 2.
- Page 4 The strip may be cleaned by using a damp cloth with mild, non-abrasive cleaners. Do not use highly alkaline or acidic cleaners. Rinse after applying cleaners and wipe with a clean cotton cloth to dry. Questions? For more information on installation, repair or replacement, please visit www.Babcockdavis.com or call (888) 412-3726 ©2020 Babcock-Davis, Inc. Rev 8/2020...