babcockdavis BSTSB Installation, Operation And Maintenance Manual

Single-part stair treads+nosings-ribbed bar

Advertisement

Quick Links

Single-Part Stair Treads + Nosings – Ribbed Bar
Models: BSTSB

GENERAL DESCRIPTION

Introduction + Safety

Please read the complete instructions carefully before beginning any work. To ensure
proper installation and performance of the stair nosing, the following actions must be
completed by the installing contractor. Failure to do so will affect product warranty.
GENERAL SAFETY PRECAUTIONS
is solely the responsibility of the user, through its own analysis to select products suitable for their specific application
requirements, ensure they are properly maintained, and limit their use to its intended purpose. Follow proper local,
state, and federal regulations for proper installation and operation requirements.

Transportation + Storage

o Inspect all shipments and materials for missing or damaged components and hardware.
o Material must be stored in a clean, dry location.

Preparation

• Locate the packing slip(s) and/or shop drawings.
• Verify that all products listed on the packing slip are included in the package.
• Check the products for damage. If products are damaged, report a freight claim immediately
and leave the products in their packaging. If you sign for products without reporting damage
you waive your right to a freight claim and will be responsible for their replacement cost.
• Read the instructions thoroughly before beginning installation.
Stair treads and nosings are designed for years of safe egress.
Proper installation is critical to the product performance.
Locally accepted installation practices and procedures should
be followed to ensure a safe stairway system that meets all
local code requirements, including Occupational Safety and
Health Administration (OSHA), Americans with Disabilities Act
(ADA), International Code Council (ICC) and International
Building Code (IBC).
Improper selection, installation, or use can cause personal injury or property damage. It
Installation, Operation
1
©2021 Babcock-Davis, Inc.
Rev 9/2021

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BSTSB and is the answer not in the manual?

Questions and answers

Summary of Contents for babcockdavis BSTSB

  • Page 1 Installation, Operation + Maintenance Manual Single-Part Stair Treads + Nosings – Ribbed Bar Models: BSTSB GENERAL DESCRIPTION Stair treads and nosings are designed for years of safe egress. Proper installation is critical to the product performance. Locally accepted installation practices and procedures should...
  • Page 2 Installation, Operation & Maintenance Single-Part Stair Treads + Nosings – Ribbed Bar Model: BSTSB Tool List • Tamping tool • Screwdriver, Phillips • Drill (for recessed nosing) • Rabbit drill bit, 3/8” (for recessed nosing) • Screws, #10 (for mechanically fastened nosings) •...
  • Page 3 Installation, Operation & Maintenance Single-Part Stair Treads + Nosings – Ribbed Bar Model: BSTSB Recessed/Flush Mount 1. Mark and rabbit out 3/8-inch-deep channel for tread to sit into. 2. Fasten with #10 screws in pre-drilled, countersunk holes. In lieu of fastening with screws 1.
  • Page 4 Installation, Operation & Maintenance Single-Part Stair Treads + Nosings – Ribbed Bar Model: BSTSB OPERATION Photoluminescent Option Exposure Requirements: 1. The minimum amount of exposure to direct sunlight is 60 minutes 2. The minimum amount of exposure to artificial ambient illumination is 60 minutes from the following: o Fluorescent straight tube T8 or T12, 4000 –...

Table of Contents