Rompa 19280 Quick Start Manual

Page 1 of 6

CONTENTS

1 x Console (padded base)
1 x Bubble Tube
Please note: This switch will not control the early models of ROMPA
This product does not include a collar. You may wish to use a collar to secure your bubble tube
to the wall. The collar 14694 is appropriate for these bubble tubes.

ASSEMBLY

1. Carefully unpack
components.
2. Take the padded top off the
Console. This is attached by
Velcro. Pull the padded top off
firmly to release the Velcro.
3. You now should be able to see
the 'trap doors'. These are held
in place
screws in the corners.
all the screws and lift the trap
door out. Take care as these
contain staples and the wood
used is a little rough.
4. Attach the Bubble Tube tube to the chassis inside the Console. The chassis is the metal box
with a screw and washer in each corner. First release the screws and washers then align
the bottom of the tube with these holes. Replace the screws and washers once the tube is
aligned.
5. Attach the brown plastic pipe, which is already attached to the pump, to the bottom of the
Bubble Tube column.
SUPA SWITCH CONSOLE BY ROMPA
all the
by cross-head
Release
®
19280
®
Bubble Tubes.
SUPA SWITCH CONSOLE BY ROMPA 19280, KH 11.10
®
Copyright ROMPA Ltd