Rompa 17630 Manual

Page 1 of 2
BATTERY OPERATED MIRROR BALL MOTOR 17630

CONTENTS

1 x Battery operated mirror ball motor
Required, but not included: battery E, mirror ball C and spotlight

USE

CONTENTS
1 x Charger
1 x rechargeable battery
USE
Charge battery as required and insert battery into motor as above.
Do not attempt to recharge non-rechargeable batteries.

SAFETY

Always supervise the use of this product. For indoor use only.
Install a D 1.5V battery or the rechargeable battery
17631(to be purchased separately). To do this,
remove the integral metal loop A by pushing the
sides of the loop outwards gently. Remove the lid
D. Install the battery E, positive end facing towards
the mirror ball and the floor. Replace the lid and
metal loop.
Using the integral metal loop, suspend the motor
from a hook (or similar) in your ceiling.
Note: Check that your ceiling is comfortably able to
hold the weight of the motor and your mirror ball.
This motor will hold a mirror ball up to 1.2kg
(typical 15cm - 25cm mirror ball).
Suspend the mirror ball from the bottom of the
motor using the ring on the mirror ball and the hook
on the motor B.
Switch the motor on.
CARE & MAINTENANCE
Replace the battery as required. You will know
when the battery is starting to fail as the motor will
gradually turn the mirror ball more slowly.
Periodically wipe clean with a very slightly damp
cloth.
Do not immerse in water.
SAFETY
Always supervise the use of this product.
For indoor use only.

SPECIFICATION

Approximately 2.5RPM.
CHARGER & RECHARGEABLE BATTERY 17631
Size: 17cmH
BATTERY OPERATED M.BALL MOTOR 17630+CHARGER 17631, KH 9.03
Copyright ROMPA® Ltd