Table of Contents
Advertisement
6.1.
Installation Environments
1.
Temperature
2.
Humidity
3.
Caution :
・Installed Indoors
・Avoid drops of water, moisture, corrosive gases, and vapors of organic solvents.
・Avoid direct sunlight and radiation by high temperature.
・The Dust Cover (see Figure 2) keeps dust and particles out of the smoke chamber that may
enter. Don't remove it until installation is over.
6.2.
Mounting
1 ) Fix the FLS-02EC(-H2) to the wall with four M5 or M6 bolts using base 4-φ7 hole (See Figure 3) .
bolt length more than 11 (eleven) mm. It must be mounted on a ceiling or wall of sufficient
strength to support the weight.
2 ) It is normally mounted on the ceiling no less than 0.6 m ( twenty-four inch ) from a side wall,
vice versa (See Figure 3).
[NOTE] FLS-02EC(-H2) separates the base and cover and packs it
: 0 to +50 degree C
: 30 to 85%RH（However, no condensation）
Figure 2 : Dust Cover
Figure 3 : Mounting
6／13
and
ES1666
Advertisement
Table of Contents
