TdA DC535Y User Manual page 5

DC535Y/DCZ535Y, DC655Y/DCZ655Y BOOM GATE USER'S MANUAL
Right-hand boom gate (DC535Y, DC655Y) and left-hand boom gate (DCZ535Y, DCZ655Y)
Conduit
Make one input hole for electric wires. In order to protect the wires, conduits must be set into the
concrete when it is poured. Wires within the conduit shall be located or protected so that no damage
can result from contact with any rough or sharp part.
Expansion bolt (see Fig.4)
⚫
The boom gate requires a concrete pad in order to maintain proper stability. Place the boom gate
on its concrete pad and check the boom gate orientation with regard to the roadway.
⚫
Mark the base hole locations onto the cement with a pencil or similar.
⚫
Then move the operator to the side and drill the 4 holes on the marks that you have just drawn on
the concrete pad.
⚫
Insert the (4) M12 wedge expansion bolts that are provided with the boom gate into the holes or
you can use the (4) M12 bolts, these bolts must be set into the concrete when it is poured.
DC535Y, DC655Y DCZ535Y, DCZ655Y
Fig.2
Wire
The power wire size should be
2
more than 1.5mm .
The control wire size should be
2
more than 0.5mm .
PVC conduit (the conduit size should be more than
12mm in diameter)
We advise you to use two conduits: one for main
power wires, another one for control wires.
Always separate power wires from control wires.
Fig.3
5