Table of Contents
Advertisement
The time and date
recorded in ECG3 is
not accurate
ECG3 cannot upload
ECG data through the
data cable
Red indicator LED
lights up for 10s when
a measurement starts
The green indicator
LED blinks
continuously after
updating the firmware
Red indicator LED
lights up constantly
No response
CARE AND MAINTENANCE
1.
Do not attempt to disassemble, repair or modify this unit. To do otherwise will
possibly damage this unit or cause dangers.
2.
Avoid strong shocks or vibrations, or drop or step on the ECG3.
3.
Do not expose the unit to static electricity. Always disperse any static electricity
from your body before using this unit.
4.
Avoid high temperature and direct sunlight. Do not immerse the unit into water or
any other liquid as this will result in damage to ECG3.
5.
Do not keep this unit in the following ambient conditions:
-
Exposed to direct sunlight.
-
Subject to high temperatures or high humidity.
-
Wet or damp locations where water may get on the unit.
-
Dusty locations.
-
Near fires or open flames.
-
Locations exposed to strong vibration.
-
Locations exposed to strong electromagnetic fields.
Keep this unit in above ambient conditions may cause damage to this unit.
6. Wipe the ECG3 with a moistened and well wrung soft cloth using warm water to clean
the unit. Then air dry the unit.
ECG3 has a hardware
problem
The clock in ECG3 needs to
be calibrated or the ECG3
was restarted before
The data cable is damaged
Firmware error
Updating is failed and the
previous firmware has been
damaged
Firmware fault or hardware
damage
Firmware fault or hardware
damage
Contact customer service
Start a measurement and
watch the current ECG
waveform, which will calibrate
the clock in ECG3
Contact customer service to
get another data cable
Start a measurement again
Contact customer service
Push the user key for about 8s
to reset the device or contact
customer service
Push the user key for about 8s
to reset the device or contact
customer service
9
Advertisement
Table of Contents
