Battery Handling And Usage - iHealth ECG3 Owner's Manual

Portable ecg monitor
Table of Contents

Advertisement

26.
Do not be nervous or anxious when taking measurement, an unreliable will occur
otherwise.
27. Electrode of ECG3 should not contact other conductive parts including earth.
28. This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.
29. This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
30. The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user's
authority to operate the equipment.
31. This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
-This device and its antenna(s) must not be co-located or operating in conjunction with
any other antenna or transmitter.

BATTERY HANDLING AND USAGE

Do not change the battery. If the battery can no longer be charged, please contact
Customer Service.
· Please ensure the ECG3 has at least 40% power before a 24 hour measurement. If
an ECG3 does not have enough power to start a measurement, it will stop recording
ECG data and will prompt user. Please charge this unit for at least 1 hour.
· When charging is needed, please connect ECG3 to an AC adapter or a USB port on
PC with the charging cable. The ECG3 will not work while charging, please wait until
charging is complete.
· A medical AC adapter with an output of DC 5.0V, above 500mA and complies with
IEC 60601-1/UL 60601-1 and IEC 60601-1-2/EN 60601-1-2 is suitable for this unit.
Please note that the jack size is USB micro-B.
· When charging the ECG3, the ECG3 will show with different indicator indicating the
power status. See the table below for details.
· It is suggested that you charge the battery when the battery is less than 20%.
Overcharging the battery may reduce its lifetime.
Lithium battery replacement by inadequately trained personnel could result in a
hazard such as a fire or explosion.
7

Advertisement

Table of Contents
loading

Related Products for iHealth ECG3

Table of Contents