Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for EnerSys NexSys iON 24-L1-20-4.7
Summary of Contents for EnerSys NexSys iON 24-L1-20-4.7
- Page 1 Owner’s Manual Li-ion TECHNOLOGY ADVANCED LITHIUM-ION TECHNOLOGY www.enersys.com...
-
Page 2: Table Of Contents
In case the battery shuts down with a message that indicates “Battery Lockout” EnerSys must be contacted for service as the pack is locked out until a service person is This document is also not intended to substitute any training for handling and operating able to inspect the battery and then return it to Service. -
Page 3: Safety
EnerSys. 6. FIRE EXTINGUISHING The EnerSys NexSys iON battery is a sealed product, however in case of cell damage within the battery there is still the chance of electrolyte leakage, as well as other In the unlikely event of a thermal runaway, which may result in a visible release of gas hazards. -
Page 4: Handling
Li-ion batteries will be shipped at or below 30% State of ® Prior to lifting the battery, the truck must be secured so as to not move during the Charge (SOC) to comply with EnerSys policy on handling of Lithium-Ion Systems battery install or removal operation. during Transport. -
Page 5: Operator Interfaces
CDI or wires to the CDI are broken. Contact Service for repair or replacement. dashboard. The Truck iQ device must be permanently and securely fixed in a position for The CDI data can be read wirelessly through the EnerSys E Connect™ app available on the operator to view the information. -
Page 6: Canbus Connectivity
Representative for this option. Please contact your local EnerSys ® This option will require engineering consultation between EnerSys and the industrial truck OEM to ensure correct data and function are enabled. 15. ACTIVATION / DEACTIVATION OF BATTERY The battery will deactivate automatically when a no load condition (<3Amps) is detected Figure 9: Screen Two –... -
Page 7: Charging Battery
16. CHARGING BATTERY 17. TECHNICAL PARAMETERS (CONTINUED) The battery must only be charged by an EnerSys approved charger for Lithium-ion, Labeling ® which are specially designed to allow CAN communication with the battery to control The battery features the following labels type label incl. safety instruction, interface the battery recharge. -
Page 8: Transport
If any of these parts are damaged or show signs of serious wear, they need to be replaced. Please contact your local EnerSys service center for all repairs and replacements. All repairs must be done by an EnerSys technician trained on Lithium-ion products. - Page 9 23. TROUBLESHOOTING (CONTINUED) In Storage Battery Will Not Power On Check the following items: 1. Power cycle the battery 2. Review error ID checklist below Error ID Check List and Recommended Actions • If battery still does not operate review the CDI, Truck iQ™ or E Connect™ App for the most recent error ID(s) which will be given simply as a number.
-
Page 10: Appendix A: Ratings Table
TERMS AND ABBREVIATIONS APPENDIX A: RATINGS TABLE Nominal Nominal Nominal Term/Abbreviation Explanation/Description Model Number Voltage Voltage Voltage Energy Capacity Alternating Current (kWh) (Ah) Battery Control Unit 24-L1-20-4.7 25.55 19.6 29.4 Battery Data Interface 24-L1-24-9.5 25.55 19.6 29.4 Beginning of Life 24-L1-24-14.2 25.55 19.6... - Page 12 © 2021 EnerSys. All rights reserved. Unauthorized distribution prohibited. Trademarks and logos are the property of EnerSys and its affiliates except Android and iOS, which are not the property of EnerSys. Subject to revisions without prior notice. E.&O.E. GLOB-EN-OM-NEX-ION 1121...