Table of Contents
Advertisement
PRODUCT USAGE
ICE PUCK PREPARATION
1.
Fill the ice mold with water or flavoured ice base mixture of your choice.
NOTE: To keep the mold from overflowing while freezing, be sure not to fill past the fill line
visible just below the rim of the mold.
2.
Affix the lid to the top of the mold and place it in the freezer for 12 to 24 hours.
NOTE: Freezing time may vary and will depend both on the temperature of your freezer as
well as the sugar or alcohol content of your mixture.
NOTE: See "Tips for Great Results" sections in Product Guide Online for more details on Ice
Puck Preparation.
SET UP & ASSEMBLY - PREPARING TO MAKE SHAVE ICE
Before using your Shave Ice Attachment, clean it by following the detailed instructions in
"CARE & CLEANING" section.
1.
After removing the ice molds from the freezer, press firmly on the bottom and sides to help
release the puck from the mold.
2.
For Plain Ice recipes, allow ice to rest for up to 10 minutes - this is called "Tempering" and
is recommended to achieve ideal Shave Ice results.
3.
Turn the Stand Mixer OFF (0) and then unplug.
4.
For Stand Mixer with a hinged attachment hub cover: Flip up to open.
For Stand Mixer with a removable attachment hub cover: Turn the attachment knob
counterclockwise to remove the attachment hub cover.
5.
Insert the Main Housing into the attachment hub, make sure the power shaft fits into the
square hub socket. If necessary, rotate the attachment back and forth for proper fitment.
The pin on the attachment housing will fit into the notch of the hub rim when in the proper
position.
6.
Tighten the Stand Mixer attachment hub knob clockwise until the attachment is completely
secured into the Stand Mixer.
7.
Ensure that the upper lever of the housing is rotated all the way to left. If not, rotate it to the
left until it clicks into place. This will ready the attachment for use and must be completed
before loading the Ice Puck into the Ice Cup and attaching it to the housing.
8.
Remove the Ice Cup from the housing by rotating it to the right and pulling downward. Take
note of the small indicator arrow which must line up with the Lock and Unlock symbols on
the housing.
OPTIONAL: If you wish to change the blade, grip the blade from the bottom and rotate it to
right to unlock and remove.
ASSEMBLY
1.
Grip the blade from the bottom and slowly insert it into the bottom of the Ice Cup by
aligning the interlocking tabs. Once inserted, rotate the blade to the left until you hear a
"Click", to properly lock the blade in place.
NOTE: Each of the interlocking tabs is unique size, ensuring the blade can only be
installed in the correct position.
2.
Insert the Ice Cup Sleeve into the Detachable Ice Cup, then insert a prepared Ice Puck. Be
sure to insert the ice puck with the cross hatches facing upward.
3.
Attach the Detachable Ice Cup to the bottom side of the main housing, rotating it to the left
to lock it in place.
NOTE: The small indicator arrow on the Detachable Ice Cup that should line up with the
Lock and Unlock symbols on the main housing.
5
Advertisement
Table of Contents
