Elation PROTEUS EXCALIBUR User Manual page 29

S YS T E M M E N U
EDIT PROGRAM - Record Controller - Working With Built - In Programs
A Primary unit can send up to 3 different data groups to the Secondary units, i.e. a Primary unit
can start 3 different Secondary units, which run 3 different programs. The Primary unit sends
the 3 program parts in a continuous loop.
The Secondary unit receives data from the Primary unit according to the group which the
Secondary unit was assigned to. If e.g. a Secondary unit is set to "Secondary 1" in the menu
"Set to Secondary", the Primary unit sends "Auto Program Part 1" to the Secondary unit. If
set to "Secondary 2", the Secondary unit receives "Auto Program Part 2".
To start an Auto Program proceed as follows:
1. Secondary Setting
• Select "Function Mode".
• Press ENTER to confirm.
• Select "Set to Secondary".
• Press ENTER to confirm.
• Select "Secondary 1", "Secondary 2" or "Secondary 3".
• Press ENTER to confirm.
• Press MODE/ESC in order to return to the main menu.
2. Automatic Program Run
• Select "Function Mode".
• Press ENTER to confirm.
• Select "Auto Program".
• Press ENTER to confirm.
• Select "Primary" or "Alone".
• Press ENTER to confirm.
• Press MODE/ESC in order to return to the main menu.
3. Program Selection for Auto Pro Part
• Select "Edit Program".
• Press ENTER to confirm.
• Select "Select Programs".
• Press ENTER to confirm.
• Select "Auto Pro Part 1", "Auto Pro Part 2" or "Auto Pro Part 3", and select which
Secondary program is to be sent. Selection "Part 1" means, that the Secondary unit runs
the same program as the Primary units.
• Press ENTER to confirm.
• Press MODE/ESC in order to return to the main menu.
4. Program Selection for Edit Program
• Select "Edit Program".
• Press ENTER to confirm.
• Select "Edit Program".
• Press ENTER to confirm.
• Select the desired program to edit specific scenes into a specific program.
• Press ENTER to confirm.
• Press MODE/ESC in order to return to the main menu.
5. Automatic Scene Recording
• Select "Edit Program".
• Press ENTER to confirm.
• Select "Edit Scenes".
• Press ENTER to confirm.
• Select desired scene numbers. A maximum of 250 scenes can be programmed.
• Press ENTER to confirm.
• Press MODE/ESC in order to return to the main menu.
29