Table of Contents
Advertisement
11. In the event that the controller is overloaded beyond the maximum current rating, an internal fuse will dis-
rupt power. Should the controller stop functioning, or exhibit abnormal or intermittent operation, please
discontinue use immediately and send the controller to an authorised service centre for troubleshooting
and repair.
12.Excessive duty cycle will cause the tool and/or controller to overheat. If this occurs, discontinue use until
cooled down and reduce cycle rate. As a general rule, do not exceed 10-15 screws/minute, one 8 hour shift
per day.
13.The 035/E/A / CESL8 series screwdrivers incorporate a protection circuit which stops the electric scr-
ewdriver if the tool is switched from forward to reverse while running. Should this happen, the operator
must release the tool trigger and restart the fastening cycle.
14.Power the controller off and wait for 3 seconds before connecting/disconnecting the screwdriver tool
cable to/from the controller.
15.Turn the main power switch off when the controller i s not being used. Unplug the controller if it is not being
used on a regular basis.
16. Do not attempt to disassemble or repair the screwdriver or controller. Repairs should only be perfor-
med by qualified technicians properly trained in the safe operation, troubleshooting, and repair of these
devices. Please consult Bossard.
17 Use only the factory specified brand replacement parts and accessories with these tools and controllers.
18. Any damage to the tool and/or controller resulting from misuse, abuse, or failure to
follow these guidelines will void the limited warranty period.
Grounding – This controller (and AC power cord) is equipped with a 3-prong electrical
receptacle/plug with ground pin. The controller must be connected to a properly grounded AC electrical
outlet. Do not attempt to use this controller without a properly functioning ground connection. Never
connect a live circuit to the ground pin or internal yellow-green ground wire.
3.2 SETTING UP YOUR SCREWDRIVER AND CONT-
ROLLER
Unpack the tool and controller from their boxes and confirm that all items have been received and are in
good condition. The controller is shipped with the appropriate grounded power cord for connection to the
AC supply receptacle. The screwdriver is shipped with a 2 metre tool cable that connects the screwdriver
to the controller.
Select a suitable, stable location for the controller. Ensure that the location allows for the required range
of motion of the screwdriver without stressing the tool cable that connects the tool to the controller. The
cable should bend naturally and always have some play in it. Undue stress put on the cable will result
in premature cable failure. If the standard cable length is unsuitable, longer lengths are available for
purchase as an option.
If the tool is being mounted in a fixture or Linear Quick, mount the tool in the arm. 035/E/A – 40V series tools
incorporate an aluminium mounting surface directly in front of the tool grip/housing nut. Please use this sur-
face for fixturing. Fasten the tool securely to avoid it rotating in the fixture due to reaction torque. An optional
metal torque lock sleeve is available for some models to aid in mounting in a Linear Quick or a fixture.
6
The 035/E/A / CESL8 screwdriver housings in-
clude a groove for installation of the side hand-
le. Ensure that the notch inthe handle is aligned
properly withthe groove and fasten securely.
Aluminium Surface for fixture mounting for
035/E/A-40V / CESL8 40V
Advertisement
Table of Contents
