Electrolux GT316 User Manual page 73

Problem
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the SUPER, or af‐
ter changing the tempera‐
ture.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Large quantities of food to
be frozen were inserted at
the same time.
The room temperature is
too high.
Food placed in the appli‐
ance was too warm.
The lid is not closed prop‐
erly.
The SUPER function is
switched on.
The lid is not closed prop‐
erly or the gasket is de‐
formed/dirty.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
The temperature regulator
is not set correctly.
The lid is not closed prop‐
erly.
The products' temperature
is too high.
Many products are stored
at the same time.
The thickness of the frost
is greater than 4-5 mm.
The lid was opened too of‐
ten.
ENGLISH
Solution
Wait a few hours and then
check the temperature
again.
Refer to the climate class
chart on the rating plate or
to the "Installation/Posi‐
tioning" chapter.
Allow food to cool to room
temperature before stor‐
ing.
Check if the lid closes
properly and the gaskets
are not damaged or dirty.
Refer to "Control panel/
SUPER function" chapter.
Check if the lid closes
properly and the gaskets
are not damaged or dirty.
Refer to "Control panel/
Temperature regulation"
chapter.
The compressor starts af‐
ter a period of time.
Set a higher/lower temper‐
ature.
Check if the lid closes
properly and the gaskets
are not damaged or dirty.
Allow food to cool to room
temperature before stor‐
ing.
Store less products at the
same time.
Defrost the appliance. Re‐
fer to "Care and cleacning/
Defrosting the appliance"
chapter.
Open the lid only if neces‐
sary.
73