Led And Buzzer Functions; Emergency Stop - Vancare G Series Installation And Operation Instructions Manual

LED and Buzzer Functions

Charging Battery
Yes Full
No Full
Yes Not Full
No Low Battery
No Depleted
No Fault
Emergency Lowering
During Sleep Mode (When LED turns o 0 after 1 minute) the unit should draw minimum power (~1 mA)

Emergency Stop

The G-Series Lift unit also has an Emergency shut-off feature that allows the operator
to shut the power to the lift completely in the event of an emergency. By pulling
once on the RED emergency lowering cord, located on the underside of the lift, the
lift will immediately stop and all its functions will be disabled. The "ON" indicator
light will turn off, and the Emergency Shut-off button located inside the lift will pop
out. After an emergency, the lift must be inspected prior to restoring to use. In order
to restore power to the lift, the tab must be pressed back into the lift.
!
Do not pull the red cord forcefully.
For assistance after an emergency contact: Vancare Service info@vancare.com or 1.800.694.4525
LED Buzzer
Green N/A
Green N/A
Orange N/A
Slow - 1 beep every 10
Orange
seconds
Beep - 1 beep every 3
Red
seconds
Beep pattern every 3
Flashing Red
seconds
Double beep then motion
Additional Notes
LED stays on
LED stays on 1 min then shuts o
LED stays on 3 min after use then shuts o
LED stays on 1 minute then shuts o
LED stays on 1 minute then shuts o . Lift in up
direction disabled but lift is able to go in the
down direction
LED stays on for 1 min
Red LED (in main board is working) else no
LED
www.vancare.com 13