Start Rhel Operating System Installation; Configure Bios To Boot From Ssd - Dell EMC Virtual Edge Platform 1405 Series Operating System Installation Manual

8. Press 1 to select Standard Partition, then enter c to continue.
9. Enter 2 to configure the Time settings, then enter 9 to create a user.
10. Enter the required information in each of the fields provided, then press c to continue
11. Press 7 to enter the network configuration screen.
12. Select the number that corresponds to your network interface.
Figure 20. Interface selection
13. In the fields provided, enter the required network information such as IP address, Netmask, and Gateway, then enter c to
continue.
14. Enter 4 to select Installation Source then enter c to continue.

Start RHEL operating system installation

1. From the installation source screen, enter b to start the installation process.
The installation process begins.
2. After the installation is complete, remove the usb drive from the device and press Enter to reboot the system.

Configure BIOS to boot from SSD

1. From the BIOS screen, select the Boot tab.
2. Boot into the BIOS settings and select Red Hat Enterprise Linux as Boot Option #1.
Figure 21. Red Hat Enterprise Linux boot selection screen
The Save configuration? confirmation screen displays.
3. Using the left and right arrow keys, select Yes then press Enter.
Configure BIOS and install Red Hat Enterprise Linux operating system to SSD 19