Advertisement
Quick Links
Using the Pipe Connector to join the Pipes
Pipe (not included)
Pipe Connector
Cable
To extend the length of the pipes, use the pipe
connector to join the 1.5 inch NPT pipes by twisting
the male threaded end of the pipes into the female
thread of the pipe connector.
Use screws EE or DD to secure the pipes.
Cables can go through the pipe and exit from the
opening area of the pipe connector for cable
management.
IMPORTANT!
Do not loosen screws or pipes all the way when
making adjustments, this will disconnect the
parts and may cause injury or property damage.
PIPE CONNECTOR WITH OPENING
(EE)
OR
(DD)
QG-PRO-PM-PCO-B
QG-PRO-PM-PCO-W
CAUTION!
136.4kg
Do not exceed the maximum rated weight
(300lbs)
specified. Otherwise, serious injury or
RATED
property damage may occur.
5 Year Limited Warranty
5 Year Limited Warranty
Version November 2015
Version November 2015
Advertisement
Related Manuals for QualGear QG-PRO-PM-PCO-B
Summary of Contents for QualGear QG-PRO-PM-PCO-B
- Page 1 QG-PRO-PM-PCO-B Using the Pipe Connector to join the Pipes QG-PRO-PM-PCO-W PIPE CONNECTOR WITH OPENING Pipe (not included) (EE) (DD) Pipe Connector Cable To extend the length of the pipes, use the pipe connector to join the 1.5 inch NPT pipes by twisting the male threaded end of the pipes into the female thread of the pipe connector.
- Page 2 If any parts are missing or damaged, contact your local distributor or WARNING support@qualgear.com for replacement parts and do not start assembly and installation until you receive all the parts. Do not begin to install your QualGear ...