Advertisement
ASSEMBLY INSTRUCTIONS
Horizon Workstation
6 Person
Size: 1600mm
Tools Required: Power screwdriver.
Special Note: Nut inserts are provided. Line up Desktops with nut inserts to
secure legs to underside of desk top. Only the outside legs use the nut inserts.
The middle shared leg uses wood screws only.
2 persons required for installation
www.jasonl.com.au
Call us on
1300 527 665
Page 1 of 5
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Jason.L Horizon Workstation 6 Person
Summary of Contents for Jason.L Horizon Workstation 6 Person
- Page 1 www.jasonl.com.au ASSEMBLY INSTRUCTIONS Horizon Workstation Need help! Call us on 6 Person 1300 527 665 Size: 1600mm Tools Required: Power screwdriver. Special Note: Nut inserts are provided. Line up Desktops with nut inserts to secure legs to underside of desk top. Only the outside legs use the nut inserts. The middle shared leg uses wood screws only.
- Page 2 www.jasonl.com.au ASSEMBLY INSTRUCTIONS Horizon Workstation Need help! Call us on 6 Person 1300 527 665 Size: 1600mm COMPONENTS Screen x3 (1600mm) Desk legs x8 Desk leg foot insert x16 L-Shaped post bracket x12 Desk top x6 (1600mm x 800mm) Beams x6 SCREWS self-tapping screws nut inserts...
- Page 3 www.jasonl.com.au ASSEMBLY INSTRUCTIONS Horizon Workstation Need help! Call us on 6 Person 1300 527 665 Size: 1600mm Using an Allen key remove top 2 caps from all screens uprights. Bring two Attach the top plates to the outside legs. partition towards one another and slide the 2 way connector rod - down between the two screen uprights.
- Page 4 www.jasonl.com.au ASSEMBLY INSTRUCTIONS Horizon Workstation Need help! Call us on 6 Person 1300 527 665 Size: 1600mm Table top representation: Nut inserts and flat base screws to be used at holes identified with dotted lines. Wood Screws to be used in centre of desks for middle leg. Page 4 of 5...
- Page 5 www.jasonl.com.au ASSEMBLY INSTRUCTIONS Horizon Workstation Need help! Call us on 6 Person 1300 527 665 Size: 1600mm Attach outer legs + beams to Desks Top by tightening Screws into nut inserts. Attach middle legs + beams to Desks Top by tightening Screws. Use woods screws, and ignore nut inserts here.
Need help?
Do you have a question about the Horizon Workstation 6 Person and is the answer not in the manual?
Questions and answers